![]() ![]() Remove the camera enclosure from the mount by removing the screws.Some styles of mounts don’t allow the removal of the enclosure and access to the camera, preventing adjustments to the angle the lens points.Īdjusting the angle of a backup camera can be as simple as adjusting the angle of the lens within the enclosure, or adjusting the angle of the entire enclosure itself. Some cameras sit inside an enclosure that is mounted to the vehicle, and can be adjusted within the enclosure. Not all backup cameras and camera mounts are the same. How to Adjust Cameras with Different Mounts Washers, nuts, or grommets (preferably rubber to prevent damage).Possible tools needs to adjust the angle of a backup camera: Many mounts use hex screws or regular screws, so a drill or screwdriver is needed. If you need to open the enclosure that has screws and bolts, you’ll need a drill or hand screwdriver and the correct bits for the fasteners on the camera and its mount. If you need to open the camera enclosure to remove and angle the camera, you’ll need the tools to do that. Some cameras are easy to adjust within their casing, while others require tools to remove, adjust, and refasten. It can also be done by walking back and forth between the camera and the display, but there’s a higher chance for error when you do that.Īdjusting the backup camera will depend on the type of camera and how it is mounted. It’s much easier to have one person move the camera while the other watches the monitors and directs the adjustment. If any of these are the case, it’s probably a good idea to adjust the angle the camera is positioned at to maximize the driver’s view when backing up a vehicle.įirst, we recommend getting a second person to help with the adjustments. The camera is angled too low so you don’t see directly behind you.The camera is angled too high and you can’t see the ground.There are a number of reasons you ought to adjust your backup camera angle. Reasons to Adjust Your Backup Camera Angle Start browsing our inventory or check out our blog for helpful resources. In the event that it’s time to upgrade your backup camera, we can help with that too, since we are the backup camera experts. Regardless, we’ll take you through common reasons and warning signs to adjust the angle of your backup camera, as well as making sure that you have the right tools and equipment to do so. For the latter, making sure the angle was right when the camera was installed is a good idea, but perhaps you changed your mind later, or someone else who owned the car had a different preference and you want to adjust the angle of the camera to fit your preference. Maybe the angle at which the camera is set is not to your preference, or maybe the camera was not installed properly to begin with. Integration with your existing factory navigation radio(Dealer programing is required or video input device such as lockpick or navtv ), after market navigation/video display unit or stand-alone monitor.There’s a number of reasons you might need to adjust the angle on your backup camera. High quality, OEM validated components and construction When you put your vehicle in reverse, the factory or aftermarket navigation radio or aftermarket unit with video display will show a complete view of everything behind your vehicle, with a high-resolution, wide-angle Night-vision camera. This kit comes complete with tailgate bezel with integrated wide-angle camera, 22 foot video cable with reverse power output trigger wire. ![]() This kit is an OEM fit for your 07-13 Silverado or Sierra. You value your GM Truck, your family and loved ones and a quality rear vision system will protect both. Protect your family and vehicle from back up accidents!
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |